Polycarbonate PC Sheet should note
(1) cutting: hollow plate can use a sharp knife to slice, solid bar can be normal circular saws, synthetic and cutting cut, but cutting plate should be fixed, prevent vibration, and will sawdust remove, and keep the plate clean.
(2) drilling: sunshine plate punching use common drill bits, the hole diameter should be slightly higher than bolt diameter, in order to adapt to the plate of thermal expansion must cold. In addition, is apart from the plate edge 40 mm range is unfavorable punch.
(3) hollow plate and solid BanZheng reverse sides have protective film, to maintain the plate surface is bright and clean, completing the installation don't damage the film before. In the process of installation, can according to need to edge part of the protective film opened around 5 CM, wait for after the installation is complete, then tore off protective film.
(4) the transport process avoid a plank in above, nor will edge tool contact sheet.
(5) before installation should sunlight board (hollow plate) all open KongDuan aluminum sealing with with blocked, prevent the dust, and worms into the board inside affect daylighting.
(6) must will prevent ultraviolet sunlight boards are the sign of the outward side installation.
(7) in the process of installation, construction personnel shall not stand in the sunlight directly board construction. Construction was finished, the sunlight on the board should clean up the trash.
没有评论:
发表评论